Two Gun Bob
Well-Known Member
- Joined
- 2 Apr 2010
- Messages
- 12,496
If you have a combi, the settings for water temp and flo rate are on there.Not sure what the flow rate is. Have just checked the rad temp it was set at 75. Have now set it to 60. Will check the cost again next time I put the heating on.
I did do a calculi of gas heating consumption from cold recently, but cant see to find the results.
I will do another one and upload. Again, the initial flash up after 15 minutes was much higher than each subsequent 15 minute markers. The boiler runs constant without thermostatic cut off for whatever period were comfy with and then we simply switch off and enjoy until the heat dissipates.
There is a button press on the gas meter to give you a break down reading of an M3 unit for real time accuracy.
Last edited: